specification control drawing scd 55PC6362 title two conductor cable, shielded, jac keted, general purpose, 600 volt date 4-9-15 revision a this specification sheet forms a part of the latest issue of raychem specification 55pc. component wires - 55pc0214 shield - nickel-coated copper jacket - radiation-crosslinked, modified etfe cable construction details part number 1/ conductor size (awg) shield size (awg) jacket thickness (inch) outside diameter (inch) weight (lbs/1000 ft.) lower spec limit target wall lower spec limit target value upper spec limit target value upper spec limit 55PC6362-24-* 24 38 .0050 .0065 .105 .109 .113 9.34 9.75 55PC6362-22-* 22 38 .0055 .0070 .118 .122 .127 12.02 12.50 55PC6362-20-* 20 38 .0055 .0070 .135 .139 .144 16.02 16.56 55PC6362-18-* 18 38 .0055 .0070 .154 .158 .163 21.57 22.25 55PC6362-16-* 16 38 .0060 .0075 .169 .174 .179 26.21 26.96 cable ratings and additional requirements temperature rating: 200c maximum continuous conductor temperature voltage rating: 600 volts (rms) at sea level crosslink verification: 300 3c for 1 hour dielectric withstand: 1500 volts (rms), 60 hz jacket color: white preferred jacket elongation and tensile strength: elongation, 50% (minimum) tensile strength, 5000 lbf/in 2 (minimum) jacket flaws: spark test, 1000 volts (rms) impulse dielectric test, 6.0 kv (peak) shield coverage: 85% (minimum) voltage withstand (post environmental): 1000 volts (rms), 60 hz, 1 minute 1/ part number: the "*" in the part numbers above shall be replaced by color code designators with a slash separating the component wire colors and a dash separating the component wire colors from the jacket color. example: awg 22, red and blue component wires; white jacket: 55PC6362-22-2/6-9 users should evaluate the suitabilit y of this product for their application. specifications are subject to change without noti ce. tyco electronics corporation also reserves the right to make ch anges in materials or processing, which do not affect compliance with any specification, without notification to buyer. 1/ colors and color code designators shall be in accordance with mil-std-681. however, due to length limitations of the rayche m part number, an alternative color code may replace mil-std-681 color code designators. (example: "901/902..." may be replaced by "axxx".) other codes and suffixes may be added to the part number, as necessary, to ca pture any additional requiremen ts imposed by the purchase orde r. page 1 of 1 raychem, te connectivity, te connectivity (logo), and te (logo) are trademarks. raychem wire & cable 501 oakside avenue redwood city, ca 94063-3800 phone: 1-800-227-8816 fax: 1-650-361-6297 dimensions are in inches and, unless otherwise designated, are nominal. this specification sheet takes precedence over documents referenced herein. referenced documents shall be of the issue in effect on date of invitation for bid. ? 2015 tyco electronics corporation. all rights reserved.
|
